|1||Wi-Fi Energy Meter||1||Wi-Fi Module Embedded|
|2||Split-core CT (Current Transformer)||1||150A and 250A CT optional|
Please watch Video of WEM3080 Hardware Installation for guidance.
Note: The break for the meter is optional. You can connect the meter directly to the main breaker or without the breaker.
Wiring in a Single Phase Solar PV System
Wiring in a Single Phase Residential Electricity System
There are two ways to configure meter's WiFi settings. Setting up by mobile App is recommended by us. However, you can also set up it in the browser if you meet any problems when using App.
Step1, scan the QR code and download the mobile App
Step 2, search and connect the iMeter's access point signal iMeter_xxxxxxxx by your phone
Step 3, Open app and find the iMeter
Tips: If the app prompts "Invalid device version", you need to setup the WiFi network by browser, same as 3.1 WEM3162 QuickStart
Step 4, Select the SSID of your home WiFi network;
Step 5, Enter password and save. After succesfully configure the WiFi settings, you will see that the IP address allocated for the iMeter.
If you have successfully set up the meter's WiFi settings by step 3.1, then you can skip this step 3.2.
Tips: SN is the unique Serial Number of your iMeter. You can copy it from the iMeter's access point signal (iMeter_xxxxxxxx, xxxxxxxx is the SN).
Tips: Time zone must be set according to where your meter located for correct data display and report on time basis.
Tips: Please set the use type of each CT according to the actual CT installation. For example, if you clamp the CT onto grid, then you set its use type as "grid". If you have a solar system and clamp the CT onto solar inverter, you set its use type as "inverter"
View on Mobile App
View on Web Cloud
Tips: Please visit https://www.iammeter.com to login to the web portal. Same username and password as app. You can see more analysis report on web.
If you have a WeChat account, please follow our IAMMETER WeChat public ID.
Leave a comment